-
Battery Powered Smoke Detector - Wireless Fire Alarm Sensor Battery powered smoke detector battery powered smoke detector 85pcs siren sound is powered by 9 volt battery.
-
Battery life gives an audible warning in battery attenuation for 12 months technical specifications : Energy source : 9vdc operating current : 10ua (normal) and20-50ma (at the time of alarm) smoke sensitivity : 0.81-1.42% operating temperature : 40° f-100°f(4ºc - 38ºc) humidity : 10% -90% siren: 85db ~ 3m location : Your smoke detector can be placed in any place that may be an emergency.
-
It can be used in all living spaces except very narrow cabinets, bathrooms and unfinished attic.
-
It is recommended to be used in living rooms, living and dining rooms, bedrooms, kitchens, warehouses, offices, workplaces and all passage halls.
-
Warning : Research indicates that additional alarms that are properly installed and used lead to a significant increase in receiving a timely warning.
-
For maximum protection, we recommend installing a smoke detector in every living area except the bathroom.
-
Areas that should not be placed: Areas where the temperature may fall below 4°c or rise above 40° c.
-
Very damp areas, bathrooms.
-
(moisture and steam may cause faulty alarm) areas that may remain airless for too long.
-
(cabinet etc.) garages (vehicle exhausts may be due to faulty alarms) areas with very high air circulation.
-
Very dusty and dirty environments.
-
installation : Select the place where the device will be placed.
-
Remove the mounting plate under the device and mark the wall or ceiling to be transmitted through a pencil through two holes.
-
Drill holes at the points you marked.
-
Put a dowel in the holes you drilled and lock the mounting plate.
-
Open the 9v battery and insert it into its slot.
-
Place the detector on the mounting plate and turn it clockwise to lock it.
-
You can test your device by pressing the test button on it.
-
Operation : When the detector is installed, the led on it lights up approximately every minute and indicates that it is working normally.
-
When it detects burning particles (burning particles), it starts to work with a strong alarm sound and stops when the particles in the air disappear.
-
ss-168 has a further feature included in the test button.
-
If the smoke from food smoke or a non-harmful substance triggers the alarm, the detector can be silenced within 10 minutes by pressing the test button once.
-
If there is an increase in the amount of smoke within 10 minutes, the alarm will be activated again.
-
If there is no increase in the amount of smoke, your detector will continue to work normally after 10 minutes.
-
Test : It is recommended to test once a week to ensure that your detector is working properly.
-
When you press and hold the test button for 3 seconds, the alarm will start to sound and the led will flash rapidly during the alarm period.
-
This indicates that your alarm is working normally.
-
You can also test its operation by giving smoke to the detector.
-
Maintenance : The device is designed in such a way that it does not require maintenance as much as possible.
-
However, with a few small applications, you can ensure that it works properly for a long time.
-
Testing once a week, dusting with a soft brush tip once a month if there is dust on it and testing after this process, not cleaning with liquid cleaners (liquid cleaners may damage the device) If your detector emits a short signal sound every minute, it means that the 9v battery inside is weakened, replace the battery with a new one as soon as possible.


