PRODUCT BENEFITS Ease of wearing / removing: It does not wear out the bar thanks to the opening mechanism.

Ergonomic grip: Attachable in 2 seconds with one hand Robustness: Safe clamping from 5 points.

Maximum load 15 kg (one side) PRODUCT CONCEPT and TECHNOLOGY PRODUCT COMPOSITION: Chassis: 80.0% Polyamide, 20.0% Glass Fiber Arm: 80.0% Acrylonitrile Butadiene Styrene, 20.0% Glass Fiber Bar: 100.0% Steel Protection sheath: 100.0% Thermoplastic polyurethane STORAGE ADVICE: Do not leave your stop discs on your bar, remove after training USER INSTRUCTIONS: Only available with Decathlon bars Maximum 15 kg PRODUCT SPECIFICATIONS sport level: all levels

stop disc diameter: 28 mm

main component: polyamide

status: new

clamping type: arm clamp

diameter (mm): 28 mm

TECHNICAL INFORMATION Dimensions of the stop disc: Diameter when closed: - 28 mm Weight: - each piece 52 g Stop discs are sold in sets of 2, so you need to buy two sets if you are training with two dumbbells.

Why choose this stop disc? : The stop disc is an indispensable piece of equipment in bodybuilding, but its use is sometimes complicated (especially butterfly stop discs!).

Therefore, we have designed this stop disc so that you can insert and remove it with one hand in just a few seconds.

The clamping system made of 5 places ensures your safety by preventing the weights from slipping from the bar (supports up to 15 kg if the dumbbell is in the vertical position).

How to install these stop discs: Stop discs are attached to bars or weightlifting bars to secure weights during muscle-building training.

Correctly installed as follows: - Lift the burgundy coloured piece to open the stop disc.

Insert the stop disc into the bar or 28 mm barbell.

Close the stop disc by reinserting the burgundy colored piece.

Your stop disc is stuck! Don't forget to install one at each end of your bar.

Use your stop disc safely: Maximum weight supported in vertical position: - 15 kg Always check that the stop discs are stationary before starting the set.

The pressure exerted by the weight plates on the stop disc is relatively lower in the horizontal position, so we do not specify the maximum supported weight in the horizontal position.

Which weightlifting bars are compatible with my stop disc? : This stop disc is compatible with bars with a diameter of 28 mm (not serrated).

For example: - 1.20 m Z dumbbell bar (product code: 8484124) - 1.55 m dumbbell bar (product code: 8289896) - 2 m dumbbell bar (product code: 8289900) - 1.20 m dumbbell bar (product code: 8289897) - 35 cm dumbbell bar (product code: 1041986) - 86 cm triceps bar (product code: 8484125) Stop disc is not compatible with 50 mm bars.

What should I do if my stop discs break? : To ensure your safety, stop discs are not repairable.

If it breaks under normal conditions of use (according to the maximum weight), you can go to the store to find the most suitable solution.

How should I store my stop discs? : Always remove your stop discs from the bar at the end of the workout.

Store in a dry, unlit and airy place.