-
KIT CONTAINS
-
1- Aluminum bottle 2- Aluminum Cap 3- 3 piece steel decoration senses 4- Decoration senses cleaning brush 5- Protection cap 6- Tube container INSTRUCTIONS FOR USE
-
1- If you are going to use the whipped cream flush for the first time or after a long break
-
wash the bottle first with warm water and then with cold water. 2- Fill the bottle with well-cooled fresh whipped cream or other ingredients depending on your recipe. Do not fill more bottles than the capacity marked on the bottle. To prevent lumps, make sure that the solids in the material are completely dissolved before filling the bottle. 3-Place the gasket on the cap and rotate the cap so that it is properly sealed in the bottle. If the screw thread is not visible in the bottle, it means that the cap is properly closed. Do not cross-close. 4- Place the cream tube (8g N2O) into the tube container. It is recommended to use original tubes, but you can also use 8g N20 tubes in Liss or HEAT standards. 5- Attach the tube container to the valve by rotating it until there is a hissing sound. Use 1 tube for each filling. Shake the bottle four or five times, upright. When using a well-cooled light cream or other mixture, shake up to ten times, loosen the tube cup and tube. It's normal to hear a slight hissing sound when you're relaxing. Remove the metal tube. These tubes can be used as scrap and are recyclable. 6- For squeezing, hold the bottle upright with the decoration sense facing down. There should be about 1 cm distance between the socket and the surface where you will squeeze the cream. Lightly press the trigger, if the cream is not strong enough, shake the bottle once more.
-
1- Do not use sharp or abrasive objects to clean the bottle. 2- Do not put the whipped cream siphon in the freezer or deep freezer. 3- Do not expose the whipped cream flush to heat (stove, sun, microwave, etc.). 4- Turn on the whipped cream flush only when the pressure is completely lost. Press the trigger until the hissing stops. 5- During cleaning, remove only the parts specified in the maintenance instruction. 6- All parts can be easily assembled. Therefore, you don't need to use force. 7- For your safety, do not lean over the product during the process. 8- Clogging may occur in the valve due to filling the bottle with solid materials. In such cases, proceed as follows: Do not try to remove the helmet in any way! Place the bottle on top of the counter and wait for the contents to settle to the bottom. Then cover the cap with a thick cloth and press the trigger several times until the gas is completely out. If you still cannot loosen the hood, contact the company from which you purchased the product. 9- Caution: Use only original spare parts! Never use parts of the product with other products or similar products from other manufacturers. 10- Do not try to make changes to the product. 11- Use original tubes if possible. 12- Siphons and tubes are pressurized products, care must be taken when using them. 13- Never damage the product



