-
It does not require a master, it is a tenant-friendly product.
-
First of all, make sure that the surface you will apply is clean and smooth.
-
Wipe the surface with glass or water, but not too much.
-
Remove the protective layer behind the foil a little.
-
Using a scraper (such as a ragle or a flat plastic) or by pressing it sideways from the middle of the side where you will attach the foil with the help of a cloth and slowly opening the rear protective layer towards the surface.
-
If the foil is placed incorrectly, you can open it and apply it again with the same method.
-
After application, let it dry for a while.
-
Heat with a Hair Dryer.
-
You can easily bend the evanescent places by heating them with a blow dryer.
-
When the liquid you apply to the surface dries, the material will be made at full strength.
-
The liquid you will apply when bonding is important in terms of both being easy to apply and preventing the formation of blisters.
-
Depending on the request, you can cut it into squares and apply it piece by piece, this way it will be easier to apply.
-
When you are going to disassemble it back, you can easily disassemble it without damaging the floor by heating it with a blow dryer.
-
You can easily cut it with scissors and model blades and adjust it to the size you want.




