No Master Requires It is a Tenant Friendly Product - First of all, make sure that the surface you will apply is clean and smooth.

Wipe the surface with glass or water, but not too much.

Remove the protective layer behind the foil a little.

Using a scraper (such as a ragle or a flat plastic) or by pressing it sideways from the middle of the side where you will attach the foil with the help of a cloth and slowly opening the rear protective layer towards the surface.

If the foil is placed incorrectly, you can open it and apply it again with the same method.

After application, let it dry for a while.

Heat with a Hair Dryer.

You can easily bend the evanescent places by heating them with a blow dryer.

When the liquid you apply to the surface dries, the material will be made at full strength.

The liquid you will apply when bonding is important in terms of both being easy to apply and preventing the formation of blisters.

Depending on the request, you can cut it into squares and apply it piece by piece, this way it will be easier to apply.

When you are going to disassemble it back, you can easily disassemble it without damaging the floor by heating it with a blow dryer.

You can easily cut it with scissors and model blades and adjust it to the size you want.