DEFINITION Elastomeric acrylic copolymer is a resin-based, water-based, single-component, ready-to-use, elastic, white colored sliding waterproofing material that can be easily applied to all types of floors.

USAGE AREAS It can be used indoors and outdoors, horizontally and vertically, on flat and inclined roofs, terraces, balconies, pools and water tanks, gutters, eaves and chimney edges, surfaces such as concrete, plaster, brick, zinc, galvanized, briquette.

FEATURES Ready to use.

It is very easy to apply and has semi-fluid feature.

Therefore, it can easily cover very difficult surfaces.

Labor cost is low.

It is elastic.

1 to 1.5 mm.

shows 600% elongation after 24 hours at 23°C in thickness.

Provides excellent adhesion to all kinds of building materials.

(Adhesion strength on mineral-based surfaces: 7.15 kgf / cm2 ).

Preserves its elasticity in hot and cold differences.

(476% at 70°C, 397% at -17°C).

Resistant to weak chemicals.

Provides respiration on surfaces.

(Water vapor permeability: 27.6 g/m² day at 65% humidity at 23°C after 24 hours).

Tensile strength

24.5 kgf / cm2 at 23°C after 24 hours and 55 kgf / cm2 after 72 hours.

Solvent-free.

TECHNICAL SPECIFICATIONS Figure : Semi-fluidic liquid Color : White Density : 1,29 ± 0,05kg/lt Elongation at break: At least 600% Adhesion strength : 12 kgf/cm2 APPLICATION SUTUT

should be applied to moisture-free, dry and clean surfaces.

All kinds of oil, dirt, dust and loose ground that will prevent the adhesion of the product on the surface to be applied have to be cleaned.

Plaster and concrete surfaces are recommended to be cleaned with soapy warm water before application.

The surfaces to be applied shall have a slope that will not cause ponding (min.

5%).

Gaps in the floor, pits have to be filled with repair mortar Stako.

Depending on the condition of the surface, the Sutut should be thinned with 100% water and a coat of primer should be applied without thinning it twice.

(Application should be done in a minimum of two layers.

) The second floor should be applied 90° perpendicular to the first floor.

Fibered Sutut should be applied as a strip at horizontal and vertical junction points.

The suture should be applied between +5 °C and +35 °C, especially in dry weather.

Application should not be made in weather conditions such as rain, snow and frost.

Applied surfaces have to be protected from these weather conditions for at least 24 hours.

WARNING All surfaces to which sutures are applied must be protected with screed, ceramic or similar coatings in order to show the necessary resistance against external influences.

The application tools are cleaned with water.

It is recommended to apply with flat rubber shoes while applying.

It is recommended to build a separate platform, especially if the satellite dish, solar panels and water tank are to be installed on it.

DRYING TIME (at 20 °C 65% HR) First drying 12 hours.

The second floor is 24 hours.

Full drying 48 hours.

Consumption of THE applied surface

for each coat depending on its structure, roughness and porosity

0.750-1 kg/m² in the average vertical and 1-1.5 kg/m² in the horizontal.

Consumptions given are approximate values and

since there will be differences according to the pore and gap structure of the surface, the exact consumption will be determined at the end of the work.

STORAGE Protecting from moisture, frost and direct sunlight

It can be stored for 1 year in its original packaging stored in a cool and dry environment. Detailed information about the product can be found at.