Materials Required • Glass sandblasting foil • Spray bottle • Water • A few drops of dishwashing detergent • Rakle (plastic scraper) • Utility knife • Ruler or meter Application Steps 1. Clean the Glass Completely clean the glass surface to be applied from dust, dirt and oil.

2. Measure the Foil and take the Precise Glass measure and cut the foil so that it is about 1-2 cm more than each side.

3. Prepare the Water Mixture Fill the spray bottle with water and add 2-3 drops of dishwashing detergent and mix.

4.Wet the Glass Spray the prepared water mixture abundantly on the glass surface.

5.Insert Foil Carefully remove the protective carrier.

Gently spray water on the adhesive surface of the foil and place it on the glass.

Thanks to the water, you can position the foil easily.

6. Remove Water and Air Bubbles with the rack Press the middle towards the edges using the rack.

Thus, the water and air remaining inside are expelled.

7. Excesses Be sure Carefully cut the excess parts of the foil at the edges using a utility knife with the help of a ruler.

8. Allow to Dry Light traces of water that may occur after the application will disappear spontaneously within a few days.

The foil fully adheres to the surface in approximately 24-48 hours.