Closed Case Water Purifier 5-Piece Filter Standard Membrane Set 5-Piece FILTER REPLACEMENT and WASHING STEPS 1- Close the water inlet valve of your device, open your treatment tap and empty your tank.

2- After completely draining the water inside the tank, close the valve of your tank.

(If the water in your tank is not completely drained in this section, read the NOTE.

) 3- Install the filters by paying attention to their inlets and outlets as shown in the diagram.

4- Place the membrane carefully in its place.

Place the double black sealed part so that it fits inside the membrane container.

With the help of hook and loop/pliers, hold the outer white plastic part and push it slightly to the right and left.

Remove the hose from the outlet of your filter 5- 2, open the valve of your mains water and perform your pre-filter washing.

You can also tap around the filters while providing water flow for 2 minutes.

Close your mains valve and replace the hose.

6- Open the valve of your tank, the valve of your mains water and your purifier tap.

7- With the help of a light, check your connection parts for water leakage.

8- At first, thin and black water will flow from your faucet.

At this stage, lightly tap around your sweetener filter, then close the lid of your appliance and place it in its place.

9- Turn off your purifier tap and turn on your purifier tap again after an average of 1 hour and drain the water accumulated in your tank.

10- After filling and emptying in this way, you can drink your water with peace of mind.

Thank you for choosing us, we wish you a healthy day.

NOTE: If the water in your tank is not completely drained, the air in your tank is reduced or exhausted.

Afterwards, you can contact us and get detailed information from our technical support team about the procedure you will perform to breathe air.