ECA Nita White Kitchen Sink Mixer with Flexible Tip 102118110 Product Features Flexible nozzle with adjustable nozzle length and height Water flow rate at 3 bar pressure maximum 7.2 lt per minute.

For codes with ”ST”, it is 5 lt per minute Before Installation: • Please review the manual before installing your armature in its place.

Keep your manual for the warranty period of your armature.

Keep your fixture in its original packaging until it is installed.

If the mains pressure is above 5 bar, working at this pressure for a long time will shorten the life of your armature.

Therefore, to the installation entrance E.

C-

Use A pressure reducing regulator.

To the entrance of the installation where you will connect your armature.

C-

Install A filter.

Before connecting your armature to the installation, clean the inside of the pipes by draining some water.

To connect the sink and sink faucets to the installation E.

C-

Use Spacer with A Filter.

Chrome plated armatures are used in hot springs, etc.

DO not use ON floors.

Do not leave your luminaire attached for a long time in buildings under construction.

Construction mortar, lime, etc.

materials can be poured on the armature.

In addition, chemicals in the air may combine with the humidity of the air and cause deterioration on the luminaire surface.

If such materials fall on the armature during construction and stick to it, do not scrape them using hard objects.

If the luminaire will stay in the buildings under construction for a long time, put a bag on the luminaire and isolate it from the environment.

Your luminaire is designed to operate between 5°C and 65°C ambient temperature.

Take the necessary precautions to prevent your armature from being affected by frost, especially under environmental conditions below 5°C.

During Installation: • During the installation of your armature, do not touch the surfaces of your armature with the key, especially the pipe key.

Use an installation template during the installation of pipelines in order to make the installation of bathroom, sink and sink faucets on the wall easy and smooth.

Never use a key when mounting the flexible connection hoses of the sink and sink faucets to the body.

The sealing element (O-ring) at the end of the hoses entering the body is sufficient for sealing.

Make sure that the hoses are properly mounted on the body.

After connecting your armatures to the installation, open the valve and observe whether there is a leakage at the connection points of the armature.

If there is a leakage atthe connection points, make a proper arrangement to seal the connection.

Do not use the luminaire without checking for leakage.

During use: • Wiping your fixture with a soapy cloth and drying with a dry cloth is sufficient for cleaning.

In places where water hardness is high, you can prevent gray spots on the surface by wiping the luminaire surface more frequently.

To clean the luminaire surfaces, do not use green sponges or dishwashing strands on one side containing abrasive and hard materials, or cleaning agents containing acid.

Wipe your fixtures once every six months or with a soft cloth when necessary.

In case of failures that may arise from all kinds of environmental conditions and usage errors, the original E.

C-

Use spare parts.